APPLICATION DATA METHOD: Brush, Conventional Spray, Roller(Pressure Pot)

NUMBER OF COATS: 3

DRY FILM THICKNESS PER COAT: 2 mils (5.1 wet mils)

COVERAGE: 300 sq. ft/gal.

APPLICATION TEMP: 50° F. Min. / 95°F. Max.

THINNER: Viny-Lux® Solvent 355 or Special Thinner 216

PREVIOUSLY PAINTED SURFACES: Remove, unless it is vinyl based. Scrape and sand old vinyl coatings which are not adhering, clean and dry surface. Remove antifouling paint in poor condition with Interstrip Semi-Paste 299E.

BARE FIBERGLASS: Begin by scrubbing well using soap and water and a stiff brush. Rinse with fresh water. Sand with 80 grade (grit) paper. Remove sanding residue. Wipe with Fiberglass Solvent Wash 202.

BARE WOOD: Sand with 80 grade (grit) paper. Clean with Special Thinner 216. Apply 1st coat thinned 10% with VinyLux® Solvent 355.

BARE METAL: Sandblast and apply 4-5 coats of Interprotect® 2000E/2001E. If blasting is not possible (or if more than 2 hours has passed since blasting) sand or grind with coarse emery cloth and apply a self-etching primer prior to Interprotect 2000E/2001E or Interprotect 3000/3001.

DO NOT USE THIS PRODUCT ON ALUMINUM HULLS AND OUTDRIVES.

APPLICATION INFORMATION: Apply 3 coats of VC Offshore*. BURNISHING: After the final coat of VC Offshore* has cured, wet sand with 400 grade (grit) paper, removing any imperfections in the coat. Burnish with fine bronze wool until a shiny, super smooth finish is obtained. Apply an extra coat if wet sanding or burnishing. Conventional Spray Pressure Pot: Pressure: 3.44-4.08 bar/50-60 psi (gun pressure), pot pressure 10-15 psi. Tip Size: 1.8-2.2 mm/70-85 thou. Spraying of antifouling paints is prohibited in Canada. Other Do not apply thin coats. Do not apply VC Offshore* in thin coats as this will lead to a rougher surface and additional sanding. It may also lead to premature fouling. Product temperature should be minimum 10°C/50°F and maximum 29°C/85°F. Ambient temperature should be minimum 10°C/50°F and maximum 29°C/85°F. Substrate temperature should be minimum 10°C/50°F and maximum 29°C/85°F. Apply to clean, dry, properly prepared surfaces only. Bare surfaces must be sanded. Do not apply VC Offshore* over non-vinyl antifouling paints. Do not apply VC Offshore* over aluminum. Do not use on aluminum boats, outdrives or outboards without proper barrier coats.